Taurus Firearm Forum banner
1 - 3 of 3 Posts

· Registered
Joined
·
3,394 Posts
Discussion Starter · #1 ·
He guys I just got some fire sights for my 24/7 ds 9mm. I have a question #1 their is a small gap under the rear sight, I would say about 0.10 of a inch is that going to be a problem because of that plate under the sight. #2 these sights seem to sit a little higher that the stock ones. How will that effect my hold I was covering the target with the factory sights. thanks.
 

· Registered
Joined
·
10,439 Posts
There have been several other threads here about the Williams FireSights on Taurus pistols such as yours.
That tall front sight moves the impact DOWN as you have to LOWER the muzzle to get the same sight picture.

There should be no great problem with the rear sight, BUT the FRONT sight is too high, and may not work in gun-specific holsters.

I wrote a lengthy commentary here where I explained why i replaced the FRONT Williams sight with a HiViz.

Bumper Auto part


Yellow Knife

Williams Rear HiViz Front

Firearm Gun Trigger Starting pistol Gun barrel

Williams Rear - HiViz Front


Auto part Electronic device Airsoft
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top