Taurus Firearm Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
132 Posts
Discussion Starter #1
Where can I get a Extractor and Ejector and the springs and pins for a Millennium? Taurus told me these parts are restricted and I find this to be the biggest joke.
 

·
Registered
Joined
·
5 Posts
i was told the same kind of thing when my 669 revolver broke. hope you don't need it back soon. :-\ might look around on gunbroker.com somtimes you can find taurus parts on there.
 

·
Registered
Joined
·
132 Posts
Discussion Starter #4
my extractor has a chip after about 3000 rounds and I figured since I am ordering then I might as well pick up an ejector and the small springs at the same time............just in case a spring jump out while cleaning in the future.

These parts are only like $1 and $2 each so I figured I might as well get a backup set of all the small parts and springs as it does not make sense to buy a few parts for $3 and pay $7 shipping............might as well take full advantage of the shipping cost to order one of everything.

Well, little did I know.......no ejector and extractor.............and these are probably the most two common parts that chip or crack since they take a beating and not very meaty as the barrel.

More reason to stick to glocks :)
 

·
Registered
Joined
·
132 Posts
Discussion Starter #6
mrglock said:
I am curious kashdaddy, did they say exactly why these parts would be considered 'restricted'?
They did not say.................but, yet the barrel and frame are not restricted.
 
1 - 6 of 6 Posts
Top