Taurus Firearm Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
6,000 Posts
frame might not be bent could be the cylinders crane is loose or something.

dunno if this a safety hazard or not.. i would'nt think it to be to serious since revolvers are kinda loose in that area anyway thats why there is a forcing cone because the design does'nt allow it..

but im sure someone who knows more about wheel guns can chime in on this.

EDIT: i should really read my own posts what i meant was thats why there is the forcing cone to give the gun some tolerances unlike a semi which is chambered in the barrel itself the revolver has to jump a gap.. the chamber is basically a moving part so it's almost impossible to line it up perfectly.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top