Taurus Firearm Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
I bought my wife an 856 Hylite in .38 Spl. for our anniversary (great for brownie points!). I was told that they were based on the S&W J-frame revolvers. I bought her 2 HKS speedloaders for Christmas.
The ones I bought will not fit. After looking closely, I found that the loaders are a little bit too large in diameter. Is there anyone out there that can tell me which ones might work?
 

·
Member Emeritus 1946-2018
Joined
·
35,996 Posts
I can't help you with your question, but I am happy to be the first to welcome you to TaurusArmed.net! :wave:

We are blessed to have many knowledgeable, friendly, and helpful gals and guys on this forum, which makes logging onto this site a daily pleasure.
 

·
Registered
Joined
·
10,732 Posts
Welcome from the Northwoods of MN.

Boy some guys will do anything to get on the little womans good side. LOL!
 

·
Administrator
Joined
·
35,117 Posts
It may be getting stuck on the width of the grips. If it is, then you wouldn't have much choice other than to find some narrower grips or to use speed strips.
 
1 - 7 of 7 Posts
Top