Taurus Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Not sure what section this best fits, but....
Has anyone made speed strips from kydex for your revolver?
Just thinking about that when I found a few scraps
Thanks
Jeremy Bays
 

·
Administrator
Joined
·
35,714 Posts
I would think that Kydex is a bit too stiff, because the way you're supposed to feed them into the cylinder requires some flexibility in the strip. Most speed strips I've seen, and I own a couple too, are like rubber. You can feed two rounds into the cylinder at a time, bending it almost in half, essentially peeling the rounds out of the strip and into the cylinder. Then you turn the cylinder, and feed two more in, then one or two more, depending on if you have a 5 shooter or a 6 shooter.
 

·
Registered
Joined
·
37,070 Posts
Perhaps if you get some Super Glue or Duct Tape you could make you a new holster with the Kydex???
anything is possible with Duct tape!
 
1 - 4 of 4 Posts
Top