Taurus Firearm Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
176 Posts
Discussion Starter · #1 ·
I can't seem to find the right size allen wrench,does anyone know the correct size? This is for a pt-1911 front and rear sight.
 

·
Registered
Joined
·
36,916 Posts
I can't seem to find the right size allen wrench,does anyone know the correct size? This is for a pt-1911 front and rear sight.
NOPE!
they are them furren sized screw heads and I am pretty sure they are not the same size (front and rear) to add to your joy.
sumbuddy here will be more knowledgeable than I here soon I bet.
 

·
Registered
Joined
·
3,908 Posts
I believe they take a 1.5 mm allen wrench. At least I read that at some point and made a note of it. I have one that came with the gun.
 

·
Registered
Joined
·
176 Posts
Discussion Starter · #4 ·
I have the one that came with the gun also,wonder if screw head is filled with loctite.My eyes arn't that good any more.
 

·
Super Moderator
Joined
·
20,061 Posts
On my Taurus 1911 the Allen wrench that came with the gun fit both the front and rear sight set screws.
 
1 - 6 of 6 Posts
Top