Taurus Firearm Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
57 Posts
Discussion Starter #1
Ok guys and gals here is my problem. I was cleaning my PT1911 today and after reassembling it I racked the slide a few times then it jammed. I can cock the hammer and pull the trigger( hammer doesn't drop fully) the safety will not engage or disengage, the slide will not move. Any ideas?
 

·
Registered
Joined
·
82 Posts
Maybe the slide stop pin did not go through the barrel link hole. Can you remove the slide stop and start over?
 

·
Registered
Joined
·
57 Posts
Discussion Starter #4
Okay took it to the smith today. As I thought it was the darn ambi safety. It had jammed. $50 to fix it and that included a new Wilson safety. :)
 

·
Super Moderator
Joined
·
21,439 Posts
Well there you go found a problem before it cost you your life and you got a better safety :)
 
1 - 5 of 5 Posts
Top