Taurus Firearm Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5,231 Posts
Discussion Starter · #1 ·
Need some help. Can someone post the measurements on the butt plate/factory recoil pad for the Rio Grande 30-30 model? Longest and widest points... please! :)
 

·
Registered
Joined
·
4,672 Posts
I can do it when I get home tonight if no one else jumps in before then.
You're wanting the height and width measurements as if you're looking at the rear side of the stock?
 

·
Registered
Joined
·
4,672 Posts
I measure:


42mm at the widest point
115mm tall on the gun stock side
119mm tall on the shouldered side
25mm from gun stock side to shouldered side (pad thickness)
Screw holes are 75mm apart, center to center
 

·
Registered
Joined
·
5,231 Posts
Discussion Starter · #4 ·
I measure:


42mm at the widest point
115mm tall on the gun stock side
119mm tall on the shouldered side
25mm from gun stock side to shouldered side (pad thickness)
Screw holes are 75mm apart, center to center
Yes, sir! Thanks a lot for getting this info. Am thinking of adding a recoil pad as well, and my gun is over at my in-laws locked up in the safe! Not sure when I'll be out there again.

Cheers!
 
1 - 4 of 4 Posts
Top