Taurus Firearm Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
6,940 Posts
How does one obtain such wonderment? and what was the cost involved? this a diy or a smith job?
 

· Registered
Joined
·
46 Posts
Machine work on slide done by gunsmith, also drilling and tapping for the mounting screws. That was around $100.00, sight came from Brownells and was around $250.00 or so with freight. Anything else done I did myself (didn't manufacture the parts).
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top