Taurus Firearm Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
Hello out there. I just purchased a new pt92 stainless. I love shooting this gun, and really like looking at it. I have only put a couple of boxes of shells through it so far. The problem is, it is difficult to reassemble the slide back on the frame. ( seems to bind about half way back on) Am I doing something wrong, or will it get easier as I put more rounds through it? Thanks. I really enjoy the blog.
 

·
Registered
Joined
·
24,936 Posts
There are many how to videos on YouTube. Look for the one you need.
 

·
Administrator
Joined
·
40,549 Posts
The only problem I ever had with my PT92 in reassembling, was getting the locking block back in place. Had to hold my mouth just right. You might check that carefully. Other than that I got nothing.
 
  • Like
Reactions: olfarhors

·
Registered
Joined
·
2,642 Posts
I have found that holding it frame down, that is, putting the slide on upside down sometimes works best. It's an old technique I used in the Army.
 

·
Registered
Joined
·
4,733 Posts
The only problem I ever have reassembling my pt99 is the firing pin block lever needing to be pushed down so the slide will go the last inch and a eighth.
 
1 - 5 of 5 Posts
Top