Taurus Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter · #1 ·
The front sight on my PT845 is waaay to the right from the factory and I need to move the sight back to center where it (should) belong. The problem is I can't find an allen wrench to fit it! I've seen lots of comments about the front sight usually being 1.5mm or .05". Mine is most definitely NOT a 1.5mm! The 1.5mm completely covers the entire set-screw.
Does anyone have any idea where I could find a smaller wrench? 1.5mm is pretty much the smallest I've seen in any set. I bought a set of actual Allen wrenches just for this and came up short!
 

·
Registered
Joined
·
31 Posts
Discussion Starter · #2 ·
Problem solved! I found a Kobalt multi-wrench folder that had a .05" wrench and I used my soldering iron to soften the thread-locker and it came right out! Now, to get to the range and sight it in!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top