Joined
·
354 Posts
Trying to remove the firing pin from my 809 and the metal keeper, in the rear, that keeps the firing pin guts from flying out seems to be jammed in there from the factory.
It was installed slightly canted so the hammer doesn't get an even re-cock when fired. I don't want to scar it all up by prying it out, but I sure don't want the cost of sending it back to Taurus just to fix that.
Anyone else run into the same problem and, if so, how did you resolve it?
Thanks......
It was installed slightly canted so the hammer doesn't get an even re-cock when fired. I don't want to scar it all up by prying it out, but I sure don't want the cost of sending it back to Taurus just to fix that.
Anyone else run into the same problem and, if so, how did you resolve it?
Thanks......
