Taurus Firearm Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
My wife wants to do the two tone blued/stainless treatment to her PT1911 since the full stainless model may never be released in my lifetime. I got all the stainless parts she wanted and went to work on it. My only problem appears to be that the hammer strut pin is stuck or penned into the hammer assembly and I cannot remove it to replace the hammer. It has a little indentation on both sides of the pin. I don't have another pin and hammer strut or I would just swap out the whole thing. I don't want to ruin a perfectly good strut/pin/hammer. Anyone got some ideas on fixing this little baby up?
 

·
Registered
Joined
·
71 Posts
Put the assembly in the freezer for about 24 hours.
Pretty sure if you are looking at the back of the hammer, it should drift right to left.
Meaning use the punch on the right side.
 
1 - 3 of 3 Posts
Top