Taurus Firearm Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #1 ·
This happened about a week ago when I went shooting, towards the end of the session.

I had bought some Remington 150gr SJHP rounds and wanted to fire some from my 605 and my Ruger GP-100 to see how they worked in each gun.

After about 20 rounds from the Taurus, the pin on the back of the cylinder would not spring out and engage the catch inside the frame, underneath the firing pin. I am not sure how to fix this problem other than taking it to a 'smith, but I would like to try to fix it myself if possible.

Any suggestions, comments, advice would be welcome.

Gunner4h1r3
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top