Taurus Firearm Forum banner

? on mil pro 140 and mil pro 111

1018 Views 3 Replies 4 Participants Last post by  Qwiks draw
i just got a third gen mil pro pt111 in 9mm with the new sa/da and i have a second gen mil pro pt140 in 40sw dao , question is can i switch the barrels on these put the 40 in the 9 slide and vice versa and shoot them safely or is it not a good idea?
1 - 4 of 4 Posts
I would think not. Breech face differences if nothing else. I expect that the extractor would be iffy as well.
Sounds dangerous to you and your gun, but im not a gunsmith so I don't know.
Would not be a good idea to do this. The operating pressures,tolerances and specs are different and do not match up to do this. Potential harm could result if you even get that far.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.