[tmb1971]

can someone tell me how the back strap is held in place on pachmyer grips with finger grooves taurus pt 99 the only thing i can figure is that it pinched between the main grip and the fraim,theres no screw holes for the back strap

 

[Robby]

Welcome aboard from the KY, Horse Country!! Don't have an answer to your question though.

Be sure to check out the Sticky's in each section, and FAQ !!!

 

[CompOSS9mm]

Welcome from Central Pa!!

If you already have the grip you can contact Pachmyer and Im sure they will send you the screws you need or they will tell you if stock screws will work.

 

[VTB_Gunner]

Welcome from Arizona! Not sure about Pacs on a PT99, but the stock screws fit the Pacs on my PT1911.

 

[Shokr21]

Welcome from Central Iowa

I just put pachmyrs on my pt92, and it was a pain for sure, a lot of stretching and hoping for no tears in the rubber. Good luck it just takes some doing.

 

[whodog]

Welcome from N Carolina!!!

 

[ccviper]

Welcome from Kentucky!

 

[MilProGuy]

It is my distinct pleasure to welcome you to the humble abode of TaurusArmed.net,
where the most knowledgeable and firearms-friendly folks on the Internet gather to talk about everything from guns, ammo, reloading, safety drills, and even politics.

 

[Bruiser 160]

Welcome from Lapeer,Michigan.:wave:

 

[btleslie]

Welcome from East Texas to the best gun forum on the internet.

 

[ELW00D]

Welcome from Oklahoma. Yes the stock screws will fit.

 

[calcustom]

Welcome from CA

 

[Montkun]

From one Pennsylvanian to another, welcome to TA. You should be able to use the stock screws, you just have to gently persuade them.

 

[Colman]

Welcome from the Texas coast.

 

[garyh]

Welcome from North Texas.

 

[Harrychl]

Welcome from Fort Worth, Texas where the West Begins..

 

[Shinsou]

Welcome!

 

[Fishinkeylargo]

from the Florida Keys! :wave:

 

[Smokewagon]

Welcome from West Texas! :wave:

 

[Lil Beaver]

Welcome from the Northwoods of MN.