Taurus Firearm Forum banner
1 - 1 of 1 Posts

· Super Moderator
36,395 Posts
Switch ammo. Sounds like the stuff you're using is leading or gumming up the forcing cone gap/barrel-cylinder gap. You can check cylinder gap with a simple feeler gauge. It should measure from .004-.007" or so. Anything tighter than .004" would be a little too tight. Sounds like your ammo may be the cause, though.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.