Taurus Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
126 Posts
Have you looked at the gap before and after it locks up? You should be able to see a little gap between the cylinder and the barrel. Just hold it up to the light for a quick check.
 

·
Registered
Joined
·
126 Posts
The next time it acts up try pulling back on the cylinder release (#17 thumb piece, http://www.taurususa.com/pdf/manual_revolver.pdf) page 19. Then see if the hammer, trigger can be moved. If so, the center pin may be in a bind due to heat, expansion, or dirt.
I had a cylinder lock up on mine that was caused by the center pin, #3, getting stuck in the cylinder and NOT unlocking the gun to allow it to be fired.
 
1 - 2 of 2 Posts
Top