Taurus Firearm Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
648 Posts
Discussion Starter · #1 ·
Hi All,
This is most likely old news, however I thought I would post my recent experience with CCI Blazer 22lr in my 970.
After shooting about 10 rounds of the Blazers my cylinder starts to bind. Granted the gap is very tight for a 22 ... about .002.
Also I got alot of misfires and the spent cases were difficult to get out of the cylinder.
I just shot 50 rounds of bulk Federal copper plated ammo with no binding, misfires or extraction problems.
I'm a newbe, but I"m guessing my problems were caused by the lube one the Blazers.
Not knocking anyones one product, these are just the issues I've had.
 

·
Registered
Joined
·
5 Posts
just got my 970, was chambering several brands and found that cci velocitor rounds I had to push in to seat properly. Very tight fit, extremely hard to eject as well, everthing else I have seated fine...little querk I guess
 
1 - 3 of 3 Posts
Top