Taurus Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
177 Posts
Discussion Starter · #1 ·
I'm trying to figure out how it even happened. I keep in next to my bed. I'm always taking it in and out of it's safe. The rear sight on my PT911 seem to have been moved a little and is now not flush with the barrel. How do you adjust that?
 

·
Administrator
Joined
·
18,422 Posts
1) Unload Pistol, if loaded
2) Place Pistol on solid Work Surface with the Rear Sights exposed end, upright
3) place a piece of thick CLoth or a Strip of Leather over the end of the Sight.
4) place the end of a blunt or Flat Punch on the area of the sight dovetail.
5) strike the Punch until the Sight is back where you want it.

Before doing this, you may wish to put some Lock-Tight or some tape into the dovetail to firm up the fit.
 
  • Like
Reactions: indomitable

·
Registered
Joined
·
177 Posts
Discussion Starter · #3 ·
Say it isn't so Joe. But it worked. Thanks. I didn't think it would be that easy.
 

·
Administrator
Joined
·
18,422 Posts
  • Like
Reactions: indomitable
1 - 4 of 4 Posts
Top