Taurus Firearm Forum banner

1 - 20 of 24 Posts

·
Registered
Joined
·
98 Posts
Nice. Is there a sleeve available to fill the gap, or somewhat fit?
Would these be better than the mags from a 24/7 which I read work also?
 

·
Registered
Joined
·
215 Posts
Discussion Starter #3 (Edited)
Nice. Is there a sleeve available to fill the gap, or somewhat fit?
Would these be better than the mags from a 24/7 which I read work also?
The X-Grip sleeve for the S&W M&P9c is a close fit, and with some minor alterations it fits my mag nicely.

DSC_5801.jpg

DSC_5809.jpg
 

·
Registered
Joined
·
215 Posts
Discussion Starter #5
Mainly sanding the bottom to make it a little bit shorter. Didn't take a lot - maybe 1/16".
 

·
Registered
Joined
·
29 Posts
Nice, I just found a new purpose for my Mec-Gar P226 18 mags. Thanks for the info.
 

·
Registered
Joined
·
4,672 Posts
I assume the Mec Gar 20 round Sig P226 mags will also work with the M&P9c sleeve since it's the 18 with a Plus Two adapter baseplate?
 

·
Registered
Joined
·
4,672 Posts
I believe it's just a slip-on, nothing really secures it other than being press fit. Not meant to be permanent so you can use the mag in the original larger gun.
 

·
Registered
Joined
·
102 Posts
It is quite loose, actually, and I won't be using the magazine in another gun...

Sent from my Mobile Communication Device
 

·
Registered
Joined
·
4,672 Posts
I don't think you'd want to secure it if it would prevent you from removing the baseplate in the future for mag cleaning
Maybe wrap some clear tape around the mag body to get the sleeve to fit snug?
 
1 - 20 of 24 Posts
Top