Taurus Firearm Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
12 Posts
Any more feedback on this sight? My stock sight white dot is about to fall out, I'm guessing from solvent working on it after cleaning.

Assuming the original sight screw is loctited into place?
 

·
Supporting Moderator
Joined
·
5,350 Posts
My G2 is outfitted with Lakeline parts, runs perfect, can't go wrong with anything bought from Al!!!!!;)
 

·
Vendor
Joined
·
865 Posts
Metal sights do have more to installing them than the plastic sights. The front sights need to be test fit, and may need some fitting, so they sit down flush, against the slide. No light should be visible under the sight from the side. That is important for both point of aim and for them to stay on. The rear sights, being metal, don't have as much give as the plastic either. They can take a little fitting to install too.

Thanks for the kind works.
 
1 - 7 of 7 Posts
Top