Taurus Firearm Forum banner

I.O. Inc stock swap to ATI Strikeforce

1405 Views 6 Replies 5 Participants Last post by  Montkun
So I bought a new stock for my AK, since I've been wanting an upper rail on the top to mount a red dot. I've been eyeing the ATI Strikeforce stock set for a while at Dunham's, and finally bought it a couple days ago. Today was the day I decided it was time to go and work on the gun for a bit. It really wasn't too hard to do at all, but i did have to pull out the Dremel and naw off a little material to make the lower hand guard seat properly around the rear sight mount. The bad part is that I can't use my folding fore grip on the lower rail, it just doesn't open up enough to slide around it so I just put the factory lower hand guard on to keep the fore grip for now until I buy a new fore grip. The pictures were taken with the replacement hand guard installed just to complete the look.

I used all three original screws (2 in the buttstock and the long pistol grip) and everything went back together without a hitch. I personally like the adjustable cheek rest, and the padding sticker was easy to line up and apply evenly across it. I really think I'm going to enjoy shooting with that Scorpion Recoil Pad built onto the stock, as it's much more comfortable than the hard ribbing of the original butt.
See less See more
  • Like
Reactions: 2
1 - 1 of 7 Posts
Very very Nice! :cool:
See less See more
1 - 1 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.