I need some help with a pt 840
There use to be a disassembly pictorial on the 800 series pistols. It ain't there anymore but I thought it was!!!
My 840 was dropping magazines out the Magwell after a couple of mag had been run through Taurus sent me a new spring and used lever that holds the mag in place. I didn't pay very close attention when I took it apart knowing I had a pictorial and instructions to replace the parts back(LESSON LEARNED) the way they should.
Could I get a 800 series owner to take some pictures of inside the magwell of the mag release I know it's a little ask but it would be much appreciated Thanks Jeff
My 840 was dropping magazines out the Magwell after a couple of mag had been run through Taurus sent me a new spring and used lever that holds the mag in place. I didn't pay very close attention when I took it apart knowing I had a pictorial and instructions to replace the parts back(LESSON LEARNED) the way they should.
Could I get a 800 series owner to take some pictures of inside the magwell of the mag release I know it's a little ask but it would be much appreciated Thanks Jeff
1 - 5 of 5 Posts
See if that is of any help,
Thank you so much I don't know why I couldn't get pictures thanks again
Did that do the trick, if not I will go pull out a PT840 and take some photos for you. Just let me know what I can do to help.Thank you so much I don't know why I couldn't get pictures thanks again
1 - 5 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Taurus Firearm Forum
A forum community dedicated to Taurus firearm owners and enthusiasts. Come join the discussion about optics, gunsmithing, styles, reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
