Taurus Firearm Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
12,813 Posts
Discussion Starter #1
Playing around with left over materials and put together a SuperTuck clone for my MilPro

 

·
Member Emeritus 1946-2018
Joined
·
35,996 Posts
That's a real fine looking holster. Good job! :thumb:
 

·
Registered
Joined
·
12,813 Posts
Discussion Starter #5
I have a clamping board with a straight edge and a template of the lower edge of the pistol (made out of scrap wood). I use a heat gun to heat up the Kydex being held by the straight edge and pull it over the pistol. Then I clamp down the template tight. Wearing thick gloves I heat spots where I want detail and push/hold down the Kydex to get the detail I want. I have been doing it this way for a while now and I find it to be quicker than using a press. It actually takes me longer and it is much harder to make the clips.

No interest in going into the holster business as I feel like I'm still learning, NTM I use the actual pistol to make my molds.
 
1 - 6 of 6 Posts
Top