Taurus Firearm Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I’m wanting to tune my Tracker 627.

The trigger is stiff and a bit stagy. Now you can tell that I must be from near a city as I really don’t
want to wait the 100’s of rounds until it all smooths itself out, if that does it.

First, having a bit of trouble removing the side plate. After removing the three screws, tried tapping the frame
with a hard plastic screwdriver’s butt, and tapping the frame against a hardwood block. Either method
moved the edge without the captured tab out a few mm, but that was all. I know it’s a precision fit, but
should I try prying? Would it be better to keep rapping harder until it’s free? It’s really in there!

I read that some models have a hole in the frameand enough room beside a spring partially covering that hole
so you can add some force to the inside of the cover plate to help free it. In my case the springs and rods behind
the likely hole do cover it completely so no punch is getting in there.

My tuning and polishing experience is mostly with auto pistols, but I am mechanicalky inclined [no, really!].
Still it would be great to have any suggestions of specific areas of the action of this model gun to shine up,
or to just knock the corners or rough spots off of.

Thanks for any tips!

Also, I’ve used Wolff spring kits before, but they don’t list this model. I wrote their tech support, and they
answered in a short time that they have no kit for this gun, so I wondered if anyone has experience tuning
this 627 model tracker and has an idea about softening the pull a little with the existing springs, or knows of
another kit or orovider of these specific springs.
 

·
Registered
Joined
·
13 Posts
They sell the Wolf spring kit on e-bay for $15.00. There is a great video on YouTube on the trigger job. It shows the areas to polish on the hammer, sear, I have this model myself and will be doing this to mine when my springs get in.
 

·
Registered
Joined
·
70 Posts
I needed a spring kit for my model 970 Tracker. But Wolff didn't list a kit for model 970. I read on a forum to use the Wolff kit for Taurus Large Fame Revolver:

https://www.gunsprings.com/TAURUS/LARGE FRAME REVOLVER/cID3/mID65/dID289

That was, indeed, the right kit for the model 970 even though that model is not listed.

If the 627 is a large frame, this should be the right spring kit.

Bayou52
 
1 - 5 of 5 Posts
Top