Taurus Firearm Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
116 Posts
Discussion Starter · #1 ·
I think I know the answer to this but I need expert advice since I know nothing about revolvers. This is a new revolver, model 617ss. Look at the edges of the cylinders and you can see what I refer to as chisel marks. In one of the pics if you count three cylinders counter clockwise from the X you can even see that the "flywheel" isnt even with the cylinder. Is this bad?
 

Attachments

1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top