Taurus Firearm Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
485 Posts
Discussion Starter · #1 ·
Yesterday I finally bought a G3c, I have carried a G2c since 2018 and it has been flawless. I am gonna continue to carry the G2c as it has been dependable and very accurate. My G3c so far has been flawless with the few rounds through it as well. I have bought up several sights for my G2c and they weren't too expensive but all I have found for the G3c hasn't been as cheap. I always like extra sights because with my health condition I fall sometimes without warning and if I damage them, I would like to be able to replace them. In the 3 years I have had the G2c, I have only dropped it one but I had to replace the back sights. I am lookin to get front and back sights for my G3c for a just in case moment. thanks for any help
 

·
Registered
Joined
·
485 Posts
Discussion Starter · #5 ·
I was looking at them a little closer and it looks like the rear is metal and should be tough but the front is polymer like the G2c. The rear might last but will still get extra, the front is polymer I am pretty sure and I will get a few xtras of it. thanks
 

·
Registered
Joined
·
130 Posts
I purchased a set of Trijicon GL05 sights which fits Glock's standard frames. It does not fit my G3c. The rear sight slides right in and slides right out. The front sight was made for a slide thicker than that of the G3c and does not tighten up. When I've shopped the Glock sights, I have not run across one that also advertises It fits any Taurus. I know Lakelinellc has a few offering, I just wanted a classic white front and rear sight on my G3c.
 

·
Registered
Joined
·
485 Posts
Discussion Starter · #8 ·
Will Glock front sights fit the G3c?, I have been reading where the rear is Glock but the front needs fitting.
 
1 - 8 of 8 Posts
Top