Taurus Firearm Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
So I've experience this and I've heard of many others. New G3C front sight comes loose after shooting a couple mags. Anyone else see this issue? I guess a 2mm hex is what you need to get her tightened up.
 

·
Registered
Joined
·
884 Posts
So I've experience this and I've heard of many others. New G3C front sight comes loose after shooting a couple mags. Anyone else see this issue? I guess a 2mm hex is what you need to get her tightened up.
Where have you Heard of these many issues with the front sight????
 

·
Vendor
Joined
·
839 Posts
I've found I need thread locker on any front sight retained with a screw, whether, Taurus, Kahr, or Glock. Blue thread locker on the screw threads AND on the base of the sight and they don't move again.
 

·
Registered
Joined
·
16 Posts
Discussion Starter #7
I've found I need thread locker on any front sight retained with a screw, whether, Taurus, Kahr, or Glock. Blue thread locker on the screw threads AND on the base of the sight and they don't move again.
Yeah that's good advice!
 
1 - 7 of 7 Posts
Top