Taurus Firearm Forum banner

G2C .40 won’t fire

1K views 14 replies 7 participants last post by  Mr. Zorg 
#1 ·
Bought it new 1.5 years ago and 800 rds through it. Today, at the range, the trigger would not move to fire and I couldn’t get the slide off. While looking at the gun a piece fell out of the magazine opening. Sending it in to Taurus for repair. Anyone know where this broken piece came from? Thanks.
Wood Rectangle Ruler Office ruler Tool
 

Attachments

See less See more
2
Discussion starter · #11 ·
Went to the range today to test it. The gun ran flawlessly, for 40 rounds. I felt a pain in my hand and was bloody. Turns out the 3 roll pins in the frame backed out to the left. Guess they reused the roll pins. I cleaned them up, applied some red locktite and knocked them back in.
Will go back to the range soon and retest.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top