Taurus Firearm Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
82 Posts
I couldn't find a brass punch, so actually cut a section out of a plastic hanger to make a plastic punch. Wasn't too difficult to tap them out with that.

Getting the firefights IN on the other hand was another story. Rear tapped in just fine, but the front was much too tight. I lightly sanded the bottom of the front sight until it could get about 1/3 of the way into the dovetail with finger pressure, then tapped the rest of the way in. Hopefully you won't need to resort to that!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top