Taurus Firearm Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
190 Posts
Discussion Starter #1
In reading up on the 709 I came across info that said the early 709 had two pins thru the frame and new ones used four pins. Is this correct? Any other identifiers(ser# break etc) to identify the newest? Been contemplating one.Thanks.
 

·
Registered
Joined
·
564 Posts
my 709 2 pin was a 2010 production model with a tcy serial # - it was replaced by the factory with a 4 pin model with a tft serial # hope this helps you out
 

·
Registered
Joined
·
5,933 Posts
Mine's a TFM, 4 pin, and according to the Taurus website, made this year (2012).
 

·
Registered
Joined
·
190 Posts
Discussion Starter #6
Can't post pics,sorry.From what I remember seeing is if your looking at the right side of frame(disregard the slide) you will see four knock out pins.2 under rear sight area.One near the take down lever.One above the trigger.
 

·
Registered
Joined
·
8,799 Posts
1 - 8 of 8 Posts
Top