Taurus Firearm Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi guys new to the forum. I have just retrieved my 1st gen stainless DAO pt111 from my daughter after not having it for about 6 years, and tried to field strip it. The slide goes forward about 3/4" and the stops like it is hitting something. Also it looks like the frame pin forward of the trigger on the left hand side is broken. There is a open hole about 3/8' deep. Any suggestions besides sending it to Taurus?
 

· Registered
Joined
·
113 Posts
Oh, yeh. So the pin was not broken? It looks like it is missing a peice on the end. It took me a few tries to figure out you have to pull the trigger to get the slide off as well. I was never much for reading instructions.
 

· Premium Member
Joined
·
875 Posts
My son has a 1st Gen PT111... and reassembling it, often times he has to turn it over for make sure the barrel catches correctly... read the instructions and it will help!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top