Taurus Firearm Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
384 Posts
Discussion Starter #1
I've been scrubbing my fingers off!! What do you recommend to clean the powder risidual off the front of the cylinder that escapes from around the forcing cone? Any special tricks or products out there you could tell me about?
 

·
Registered
Joined
·
88 Posts
Hi rainman. Do the SEARCH thing or look around on some back treads ( page 2,3,4, ). This has been talked about so much that you may not get a responce from anyone and then again, you might. For what its worth, they tell me the Birchwood Casey Lead Away Cloths great for this.
 

·
Registered
Joined
·
384 Posts
Discussion Starter #4
flounder22 said:
Hi rainman. Do the SEARCH thing or look around on some back treads ( page 2,3,4, ). This has been talked about so much that you may not get a responce from anyone and then again, you might. For what its worth, they tell me the Birchwood Casey Lead Away Cloths great for this.
Thanks flounder22. I read the threads that recommended using Flitz but it also mentioned it could change the coloring on the revolver. I've not heard of Birchwood Casey Lead Away, but will try to run some down.

NYPD in AZ said:
Is it a blued or a stainless revolver?
NYPD in AZ, It's matte stainless.
 
1 - 7 of 7 Posts
Top