Taurus Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
418 Posts
A high pressure spray can chemical like BREAKFREE PowderBlast gun cleaner in a black can can clean firearms without dissasembely. Just keep it off of plastic parts. Put the tube on the nozzle and spray in the FiringPin hole to get carbon ,gun powder,and other debris out. If you prefer to oil your FP a would use a very light oil like RemOil and wipe or blow all the excess off with compressed air.
 

·
Registered
Joined
·
418 Posts
Where do you get it ? I will look next time im in wallmart.

The firing pin and channel would only need to be cleaned after thousands of rounds,and then it would probably be best to detail strip the whole gun ,including the firing pin, at that time for a good cleaning unless the firing pin was in there pretty good with a roll pin and you don't want to bang on it. Allot of guns these days fully strip without hardly any tools or force.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top