Taurus Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
220 Posts
Discussion Starter · #1 ·
I disassembled the frame and have a quick question - the pin that holds the trigger in place is beveled on one end. Does the bevel go on the trigger bar side or the slide stop side of the frame? Or does it not matter? Thanks...
 

·
Registered
Joined
·
129 Posts
Just pulled mine apart for you. The beveled side of the pin goes on the slide stop side of the frame. Not sure if it matters or not...
 

·
Registered
Joined
·
220 Posts
Discussion Starter · #3 ·
Just pulled mine apart for you. The beveled side of the pin goes on the slide stop side of the frame. Not sure if it matters or not...
Thanks. After closer inspection and looking at the parts breakdown in the manual, I don't think it matters.
 

·
Super Moderator
Joined
·
40,649 Posts
If I get one I'll have to remember to see how it was from the factory.
 
1 - 4 of 4 Posts
Top