Taurus Firearm Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
4,960 Posts
Discussion Starter · #1 ·
How deep do I need to make the bench for a Dillon xl650 with case feeder?
 

·
Registered
Joined
·
15,149 Posts
Based on what I've seen you probably don't want it any shallower than 16-18"
 

·
Registered
Joined
·
18,376 Posts
I can't give you a direct answer. I will say that my old bench, single stage Hornady press, was 2ft. deep and my current tool box top bench is the same depth, with the Hornady AP press mounted but no case feeder.
I'd like to post a photo of my current set up but apparently this is not possible right now with this web site.
 

·
Registered
Joined
·
4,960 Posts
Discussion Starter · #4 ·
I call Dillon and they said 19 inches for a minimum depth with the XL650 and a case feeder. ( I don't have the case feeder yet)
 
1 - 4 of 4 Posts
Top