Taurus Firearm Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
625 Posts
I'm not aware of anything. I think we are anxiously holding our breaths for an aftermarket set of sights for these. I know I would buy some in a heart beat. I do not like the Heinie sights.

Todd
 

·
Moderator
Joined
·
32,942 Posts
Since these sights are dovetailed there is no reason if sights with the same dovetailed measurements couldn't be used. In the gunsmithing section or the FAQ section should be such measurements for these sights. If not having a smith or gunshop personnel check the measurements and then check their catalogs for similar setups could be done. Rezeroing new sights could be a problem. The gun was sighted in at the factory and now with a new set this could change where the guns POI is.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top