Joined
·
2,117 Posts
Just remember something, guys. (I've had no support or feedback on my earlier suggestion). When you remove that Mil-Pro third gen. front sight, heat it up w/a hair dryer and carefully tap a 1/16th hex into the metric allen screw. (instead of the recommended metric hex). It'll turn right out. Drifting out w/brass punch is a no-brainer.
This will keep you from rounding out allen screw (it's a 1.5mm) and creating difficult removal. When you finish, you'll still have a good hex wrench and usable screw. This is not "kosher" but I've done it twice now with two guns and thought I'd try to help.
smit
This will keep you from rounding out allen screw (it's a 1.5mm) and creating difficult removal. When you finish, you'll still have a good hex wrench and usable screw. This is not "kosher" but I've done it twice now with two guns and thought I'd try to help.
smit
