Taurus Firearm Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter · #1 · (Edited)
I have a question. On the Taurus 24/7 Standard .40 cal. If I drive out the 2 roll pins just above the trigger will that release the trigger mechanism so that I can lift it out along with the safety and slide lock latches??? I need to get the frame down to the bare frame so that I can do a good job Duracoating it. I don't wantr any overspray or have to mask off everything. Even with masking, without removing the trigger and latches you can't get the duracoat under the latches and it just won't look proffessional. I don't like doing anything half ass. Please someone get back to me. :confused: Thanks guys. Roy Lane
 

·
Administrator
Joined
·
18,419 Posts
Your Post has been moved to the Gunsmithing Section, where it will receive better attention as a separate thread.
Also, it tended to hijack the thread within which it was posted. A practice I discourage.

Please identify the name of the exact model of 24/7 that you have. It's listed on the Slide between the Ejection Port and Muzzle End of the Slide.
 
1 - 2 of 2 Posts
Top