Taurus Firearm Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I have a .22 taurus revolver and i just recenty removed the screw that sits just above the trigger. I put the screw back in and now the hammer wont stay at half cock and sometimes wont stay at full cock, and the cylinder does not align with the feed port. Any ideas on what i may have done to this gun ???

I would appreciate any help
 

·
Registered
Joined
·
322 Posts
I don't have an idea what might have happened to the gun, but you might want to make a post in the smithing section of this forum to get a quicker answer.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top