Kel Tec fans

[michaelfm]

The Kel Tec factory clip can only be mounted on the right side, as shown. However, see the link for after market clip.....

http://www.clipdraw.com/

These will mount on either side.

[Gopher]

Outstanding!

Thanks for that link.

[Steelheart]

When I had my P32 you could get a factory clip for both the right or left side. I got one when I ordered some accessories, don't recall which side I ordered. Not sure about the other models.

Steelheart

[michaelfm]

The P11 clip will only work on the right side, left side would interfere with the slide operation. The .32 was different. The after market clips will work on both sides.

[michaelfm]

Tried out some new ammo in the P3AT today to see how it would work. I picked up a couple boxes of "American Ammo" (Made in Miami) at the last gun show. This stuff was cheap for .380, only $7 bucks a box. 95 gr, FMJ. It worked good, with one ejection failure where the brass got stuck horizontally, (not a stove pipe) and I'd never seen that happen before. The next round didn't fully feed up the ramp, but it was close. Anyway, it cleared easily enough, and ran good from then on. Shot some of my carry ammo, Remington Golden Saber, which feeds beautifully, is very accurate and makes a nice symmetrical hole in the target. The P3AT is a little beast to shoot, though. My trigger finger is throbbing after about 12 rounds from this gun. It is definately a shoot little, and carry a lot gun. Couple of mags each trip to the range just to check function and keep ammo rotated. Love the new PT145, but still nothing beats the P3AT for BUG pocket carry.

[dblagent]

Does anyone know of comparison photos of the Taurus 145 or 745 and the PF-9 or p11? I use a neighbors 145 a lot and have held a PF-9 but have never seen them side by side.


Oh, I own a PLR-16 for my only Kel-Tec. Little large for pocket carry but still fun!

[michaelfm]

I'll take pictures of both and post here.

The PT 145 and the Kel Tec P11. The Taurus is a little "heftier", but not by much.
http://www.hunt101.com/?p=470515&c=500&z=1"][/url]

As both are double stack, the thickness is close. The PT145 is about 1/8" thicker.
http://www.hunt101.com/?p=470514&c=500&z=1"][/url]

Both I consider as conceal carry weapons. The P11 with the clip works nice in a 5 o'clock IWB carry. I'll probably carry the PT145 IWB in a left hand holster SOB.

[badman400]

I guess you could say I'm a Kel-Tec fan. At present I own 6:
P-32 (Daily carry)
P3AT (soon to be when break-in is over)
P-11 (DAT trigger)
PLR-16
Sub 2000 .40
SU-16C

Daily carry setup. P-32:

Sub2000:

PLR-16 dressed:

P-11:

SU-16C "Charlie":

[9x19]

I've got a few...

Here is my favorite... a P-11 with gray frame and hard chrome finish by Accurate Plating & Weaponry.

[djh]

This is a Kel-Tec P-32, one of the first ones manufactured. I never leave the house without it.
http://www.hunt101.com/?


p=470321&c=500&z=1"][/url]

djh