I normally wear cargo shorts and carry my 2extra TCP mags in the left cargo pocket. Of course they just flop around, so I made a little pocket magazine holder so they will stay up right and ready to grab. It will also fit my left hip pocket of my normal jeans.
I used a piece of concealex, which is similar to kydex, with a carbon fiber print. I heated it in a toaster oven, but it curls up pretty bad. It was a pain to get to lay flat enough to mold and press. So finally I just heated areas with a heat gun, and used the finger of a leather glove to form each area. It formed up better than using a foam press to mold the entire thing. One thing I noticed with the concealed is that it seems to cool faster than kydex. Once formed, I molded a curve into it so it would fit snug around the contour of my leg, or butt cheek, depending on which pocket it is in. Did a little trimming and sanding with a dremel, and was done. Its not super pretty, but effective. My next project is going to be a kydex waistband holster foe my TCP. I think I am going to shape it basically like my nemesis pocket holster, just put another "wing" on the opposite side to cut the belt loops in to.
Cool project. I like it! You did a nice job!
There is nothing in life so bad or so awful that it cannot be made infinitely worse by a lawyer.
Looks good, youngandfree.
NRA Life Member